Check out the new MinnowBoard.org website for the most up-to-date information on the MinnowBoard Turbot and the MinnowBoard.org Community.
The Tadpole Lure is a low cost "Mini-Lure" kit, providing a single GPIO-controlled RGB LED and a breakout/prototype area. Some assembly required.
Tadpole Lure Kit Components
The Tadpole Lure is an "Open Source Hardware" compatible device, licensed under Creative Commons Attribution-ShareAlike 3.0 United States (CC BY-SA 3.0)
To assemble the Tadpole Lure, a soldering iron (15-30 Watt), some electronics solder, and a pair of wire cutters (to trim wires after soldering components). You should follow good soldering techniques to safely create a proper and lasting electronic connection.
R1 12 Ohm Resistor
R2/R3 68 Ohm Resistors
R4/R5/R6 4.7K Ohm Resistors
The single RGB LED in the kit is mounted with the longest lead as the second hole from the side with a flat edge. The LED package has a flat side that gets matched up with the white line marking on the PCB.